Spout For 1 Gal Water Jugs (Equate & Great Value Jug)
Description
This is a spout I made for 1 Gal (4 Litre) jugs of water from Equate & Great Value (Walmart) jugs. This uses the existing cap with a hole cut into it just slightly smaller than the base of the funnel. Once on I used Gorilla Glue to seal it at the top. I also added a vent which helps with flow but the 123D Design file is included so you can remove the vent. I used PLA printed @ 215° & it's worked with no issues for a few months.
Statistics
Likes
3
Downloads
0