Creality Bondtech BMG Hotend for Microswiss, Stock, V6
Description
added 2 fasteners to the bottom half of the shell to keep it tight added another hole for a zip tie for the heater and thermistor modified to fit JST SYP connectors to pass the front fan electrical through and not have to deal with hanging parts and wires, these are the connectors I used: 360Pcs 2.54mm JST SYP 2 Pin Female Male Red Plug Housing Crimp Pin Terminal Connector Kit-60 Set https://www.amazon.com/dp/B07D1ZKDVF/ref=cm_sw_r_cp_api_i_ZQgqEbKSYK0GT closed up some gaps and reinforced the weak parts in the lower left area added a hole for an m3 set screw to help secure the E3D V6 hotend added some tabs in the reliefs for wire in the rear. If you print this, post a make, if you like it, please comment, if you see something that needs changing, post a comment!
Statistics
Likes
62
Downloads
0