Missile Military Coin Holders, with Dovetail connection and stand attachment
Description
so, this is a dovetail and stand added to the original challenge coin holder, because the original was glued together, and I'm not about that life. included is an original design for an AIM coin holder. dovetail connector, and dovetail with stand legs. these will fit on the standard Ender 3 Printer plate, just has to be angled to about 45 degrees, will have to finagle yourself to get right. AIM holder is designed to print with the slots down. no support, (but do you if needed), and no raft or brim. otherwise you may need to shrink it. i have not shrink tested the prints. I have printed full versions, and I'm happy with most of it. AIM print dovetails has a 2 mm divot connector in the dovetail.
Statistics
Likes
4
Downloads
0