Ender 5 Rotatable LCD Holder with LCD Cover
Description
Based off the great work by Holex01, I've updated his design in the following ways: 1. Added an optional LCD cover (see instructions below) 2. Inverted the direction of the M3 screw to allow tightening at an angle (this also required a slight tweak to the "T" piece to allow for the bolt to move) 3. Increased the tolerances of the Y piece, for slightly less that optimal printers Installing the LCD Cover: Before installing the LCD into the main case, push the Hinge Connector from the inside on the Main case, into the designated slot. The LCD will keep this in place once installed, but feel free to glue in place if it isn't tight enough. I used 2 pins as the hinge pins. [EDIT: 04 March 2020] I've designed a holder for a 6x1mm neodymium magnet which I glued to the back, and also added a similar magnet to the inside of the cover, and it is working great! The cover has a satisfying snap when you open it, and easily releases when closing.
Statistics
Likes
15
Downloads
0