Bow stand Bogenständer
Description
The original project from chemteacher628 is really well made but the piece at the top is too small for my recurve bow. I have made a bigger one, not so nice but working fine with bigger bows (up to 4,2 cm).I have also added a bowstring support that will help the bow to stay in place. You will need to print five copies of the tripod pole file (three for the legs and two for the neck of the tripod). Print the rubber foot end file with flexible filament to prevent the tripod from sliding on smooth surfaces or just glue some soft pads.
Statistics
Likes
3
Downloads
0