M5 flange for 1/4" NPT mount
Description
Mount 1/4" NPT (tapered national pipe thread) on anything with M5 screws. Used in my case to mount Loc Line on the side of my Prusa MK3S to hold a camera and a light for my OctoPrint instance. There's also a cutout in the bottom which would allow wires to be routed through and exit the flange - could be useful if you run the wiring through the LocLine in with my [T10 light shade](/thing:4116173). There was a very similar thing that I downloaded and printed quite some time ago - I tried to find it again but was unable so designed this from scratch in Fusion 360. I used a McMaster 1/4" NPT pipe cap as the starting point since Fusion 360 _still_ can't model tapered pipe threads, and then designed from there.
Statistics
Likes
21
Downloads
0