Ender 3 Glass bed clamp
Description
Clamp for Creality Glass Bed on Ender 3 Pro --------------------- The very common paperstack-clips to hold the glass bad had two downsides for me + Their handles are always sticking out or covering a lot of print area + They are too high to be used with a serious fan duct Therfore I printed my own. It's only 2mm high so the fan duct (HeroMe3 remix) can move over it. There's an hole on one side so if fit is not tight enough an M3x6 screw can help. This is made for the Ender 3 Pro with the Creality Glass Bed. Important: - Print with ABS or other high-temp material. Using PLA will do only on non-headed beds. - Print standing up ("C" from top) for optimal strength
Statistics
Likes
87
Downloads
0