Longer3D Orange 30 Drip Arm
Description
Recently purchased a Longer3D Orange 30 and to my surprise, it did not include an arm to hang prints to drip back into vat as the Orange10 did. This part is for the Orange30 specifically and allows you to hang you print diagonally to drip back into vat limited resin loss. It is designed to add/remove without the thumbscrew movement. Thought it might help others. Comments and feedback appreciated. 3-2-2020 - UPDATED: Put angle in block for better drainage.Also made post slightly smaller for better fit.
Statistics
Likes
9
Downloads
0