geoffs foldable iPhone stand
Description
I read a lot on my iPhone and also use my iPhone as a magnifier with SMD electronics - so after I changed from my iPhone7 to a 7+ I needed to add a foldable stand for the new(er) phone. I made a complete case for my 7 - but it's a pain, needing PETG and TPU, and 3D printed cases aren't quite as good as a commercial one (yet). Suddenly a light-bulb moment - just make the stand and glue it to the back of an existing case - so here it is. I actually cut a recess in the case, just because I could, but glueing it on the back would be quicker and easier - if a little wider The hinge pin is just 1mm Piano Wire cut to fit, you might need to drill out the hole, but, I didn't need to with my modified SD3 printer.
Statistics
Likes
3
Downloads
0