Microphone Desk Boom
Description
This is an almost fully printable microphone desk boom. The non printed hardware needed is: •2X Hex Head Screw 1/4"-20 Thread Size, 1-1/2" Long (7/16" Hex) •2X Nylon-Insert Locknut 1/4"-20 Thread Size (7/16" Hex) I ended up not using the screw caps and instead used real tools to tighten the bolts as it was too difficult by hand. To assemble: 1) Insert post into clamp and secure with post key. 2) Press fit post extender into the first post if additional height is desired 3) Assemble the rest of the setup according to the provided pictures
Statistics
Likes
73
Downloads
0