SecKit SK-GO Filament Sensor Mount
Description
This is a filament sensor mount for the SK-GO. It is for adding a reverse Bowden. This uses the BMG Bowden mount that came with the kit that you don't use it if you are using the direct drive. This is to set up a reverse Bowden setup. I used supports, although, I don't know that you need to. You'll need: 2 M3x16 bolts (M3x14 would be better, but I used a 16 with a nut for a spacer) 4 M3 nuts (two for the spacer on the M3x16) 2 M3x8 bolts 2 M3 T-nuts The nuts on the back are a tight fit, I used pliers to press them in.
Statistics
Likes
6
Downloads
0