Power Inlet Cover Plate
Description
This is a cover plate for a standard Rocker Inlet Male Power Socket Plug Module with Fuse Switch 6A 250V 10A 125V 3 Pin IEC320 C14. They have many names but it consists of a power plug, fuse an power switch. I made this specifically to cover the hole in a Prusa i3MK3 Delta (Black) Power Supply if you choose to remove it for some reason like I did. However, this *should* obviously work on any power inlet that has the same dimensions. This model is designed for a 2.0mm thickness frame for it to 'snap' into. I do have this in OpenSCAD but the code is insanely ugly, so Im not going to publish it here... maybe after I clean it up a bit. NOTE: The Inlet will have the spacing that it is designed for on the 4-tabs that make the actual inlet click into the your frame... I have seen 2.0, 1.5 and even 1.0... but like I said, this is for 2.0mm. No supports are needed but I printed this in Quality .1mm layers and solid infill and it worked out very nice on my Prusa i3 MK3.
Statistics
Likes
2
Downloads
0