Wall Control - Dremel bit holder mashup
Description
This mashup is a remix of a couple of different Dremel accessory holders along with my wall control hook modifications at https://www.thingiverse.com/thing:4097266 combined with my specific slicer settings (S3D) to not cover the honeycomb infill which i use to store the bits. NOTE: This is not standard peg board. It is only for Wall Control slot boards. Originally I planned on creating specific holes for each accessory tool. Not knowing future needs, I added a ton of tool holes originally. However, since each one becomes a perimeter, this significantly increased plastic and slowed down printing. After some thought, I realized I could use the honeycomb infill and then set S3D to not put a top layer, effectively making the infill the bit holders. I also added slots to store cutting wheels, drum sander, (including small), collet, and potentially a LOT of bits depending on diameter. Print settings are extremely important as it will not be usable unless you can use Variable Settings Wizard in S3D or equivalent feature in other slicers.
Statistics
Likes
96
Downloads
0