Raspberry Pi 4 Touchscreen Case & Holder
Description
This is a remix of Ender 3 Touchscreen Case & Holder for Raspberry Pi by Tronnic. I needed the case to fit a Pi 4. I also enlarged the video ribbon cable slot on the side to allow my camera ribbon cable to exit there as well. One other thing is I thickened the top rim by 1mm because it was a bit thin for my liking. Update 1.1 : I added a case with the lettering removed as per TallDonkeys request. I also added a remixed rear fan cover piece. the original was a bit too loose on my setup, so I lengthened the stands just about 1mm to make it fit my build more snugly. if 1mm is too much you can always sand to fit.
Statistics
Likes
61
Downloads
0