Pump sump/reservoir for Hot end coolant.
Description
Uses Aquarium Pump: Http://Www.Dx.Com/P/334988 To Push The Water. My First Print Leaked Slightly, The Wall Thickness Of The Reservoir Is 2Mm. Try Setting A Wider Nozzle Size Than You Are Actually Using And Run The Printer A Bit Slower To Ensure You Can Push The Extra Volume Of Filament, This Will Build Much Better Inter-Layer Bonding. Set 100% Fill Also. If Using A Tall Rostock, Mount Within 500Mm Or Less Of The Top Of The Water Tubes To Help Priming. You Will Probably Need To Prime The Pump As The Way I Have It Oriented, It Will Seal Against Self Priming. Put Someprotective Plastic Sheet Down And Towel And Siphon To Start Then Seal Up.
Statistics
Likes
2
Downloads
0