FilRight Spindle Boxes and Dropper
Description
Here's a design for storage containers and boxes that can fit in your FilRight 1.5kg PLA (and most likely other) Filament spool. There are three versions of the box: - one slot - two slot - three slot I'm planning on making a couple more that are half the size of the spindle rather then 1/4th piece. I also included a piece to put in the center area of the spindle allowing you to put more stuff in there. Added to this I have three "lifters" that fit in this cylinder so you can more easily take out the stuff you put in the box. PLEASE NOTE: the lifters have not been tested yet but should be printable/work. EDIT I added some stacking elements that allow you to stack the spindles on top of eachother so they stay in place. There are two versions, both with a longer version that can be used for more stability. Stacker Big -- Fits in the big holes that the spindle has and acts as the main spot to keep it stacked. Using these without the small ones allows you to swivel the spindle as long as you dont use the center piece with droppers as you wont be able to get it out completely. Stacker Small -- These fit in the several smaller holes. Unfortunately there seems to be a lot of discrepency in the position of these holes so matching them up might be difficult. I tried it with 4 empty spindles and not all of them matches up. They also vary in size so a little glue might be needed. I only use the Big Stackers myself.
Statistics
Likes
2
Downloads
0