Square Led light holder
Description
I needed light for a small LED directed toward the print head and the printing bed for watching printing the first layer, and I did not specifically see my request on the sites, so I designed a flexible small LED holder using the simplest equipment where I used a 3 mm thick copper cable This wire enters through two holes at the top and bottom of the design Installing the top section and at the same time making it flexible and configurable and I wrapped the inner wires with a plastic piece from an old desk light ... The result I liked quite and effective especially when printing the first layer i mount it to the extrusion by using T-nut and 3M screw ... This was the result .. I hope you like it
Statistics
Likes
4
Downloads
0