Blinky MultiMaterial
Description
This is a remix to print Blinky in 2 colors. I made 2 version: with and without alignment pins. This model is very small and the pins are useless when you print it too small. In the picture you have 2 sizes: 100% and 125% and in both cases the pins didn't fit. So unless you're printing it very big don't waste your time with the pinned version! In fact I don't think they are needed at all! Use "Align To Build Plate" in Cura to rotate the eyes. Left and right are from Blinky'S point of view ;) Good luck gluing the eyes without gluing your fingers! Don't worry, it's doable... just don't put too much glue!
Statistics
Likes
41
Downloads
0