Seneye PAR Holder
Description
I created this from scratch based on a similar design to Pikkenix model https://www.thingiverse.com/thing:3418241 However I wanted no cable ties. able to be removed (good if used as a monitor alot of the time) but hold solid. This fits a 11.7mm tube but if you print with thick walls you can certainly hone it out or just adjust before printing. Even with a 11.7mm pole you need to do light sanding to ensure a tight fit it was made very tight. it holds it solid and does not bend. I might add another clip to the pole further up to continue the cable holding too. Print with supports to ensure the cable holder and the clip guides are tight. supports are minimal and easy to remove. Enjoy.
Statistics
Likes
5
Downloads
0