TwoTrees Sapphire S E3D V6 Hotend and BLTouch Mount
Description
This is still a beta design! It will most likely change Two Trees Sapphire S E3d V6 Mount to work with DiiiCooler and bltouch * has clearance from both sides * You need to move motor mounts further out (check pictures) with a printed part or something like this: https://www.amazon.com/gp/product/B073QW9RPZ/ref=ppx_yo_dt_b_asin_title_o08_s00?ie=UTF8&psc=1 * no support needed, make sure you place on bed with flat side * proper airflow from back. * make sure you have the longer side of the heating block in the back, will barely fit diiicooler. * diiicooler: https://www.thingiverse.com/thing:1025471 and a 5015 blower fan Some info on printer: * I am running Klipper firmware on RPI4 * I use SKR v1.3 32bit board with 2208 stepper drivers * Capricorn ptfe * Original E3D Lite * Non Geared Dual Drive extruder, can easily meet 150mm/s 0.2 layer height limit of V6 without missing any steps: https://www.amazon.com/gp/product/B07WFF3Z77/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1
Statistics
Likes
5
Downloads
0