Ender 3 Angled Filament Holder
Description
I had issues with his holder. I didn't want to have to worry about bending the spool holder or not bending it enough and having the spool fall off while printing - With the original design I had issues with it falling of during a print. In this modified version I angled the holder about 2 degrees and put a stop on the end to help prevent filament roll from falling off. Printed horizontally and roller printed vertically nut printed horizontally if you need to take the stop off you can just trim it with snips I added a thickened version that the stops are thickened. I found the original stops were too thin. you will need two 608ZZ bearings
Statistics
Likes
12
Downloads
0