Bondtech CR10 Direct Drive BLTouch Support Fix
Description
Small fix on the BLtouch mount. The one that Direct Drive CR-10S direct from Bondtech offered was about 6 MM short and caused it to bend out so I added spacer nuts at first but I wanted something that was more stable of a fix so this is my remix to correct that without adding too much but giving it some tweaks to try to beef it up in spots while keeping the hardware the same, for me it doesn't matter if it's longer screws or not but for you all I wanted to simplify it. Both versions can be printed without supports but it's up to you. I will, however, include a version that uses longer screws. So the hardware required for this mount is as follows. 1x BL Touch 1x BL Touch Support 1x M2.5 Hex Key 4x M3x8 Screws 2x M3 Nuts For the Thicker version, you'll want to use 2x M3x12 and 2x m3x10ish
Statistics
Likes
10
Downloads
0