Prusa Enclosure Leg Braces - (2x #12 Screws)

Description

Thanks to Jared596 for the original. These braces have helped out a lot on the shaky, cheap Lack table legs. (The little logo isn't on this upload, it's just for personal use.) This remix is based around the #12 3/4" screws recommended by Prusa for the rest of the v1 enclosure in their blog post. (The holes are 6mm in diameter). The braces use only 2 screws instead of 4 (I was low on resources). Screw holes have a tear-drop shape for printability, there's a slight chamfer on the inside/outside of the main corner in just there's a bump, and a small triangle overhang adds bonus support to the other side of the brace. --Cheers

Statistics

Category

Tags