FLSUN i3 autolevel sensor mount for twin dual extruder sled
Description
This is a FLSUN i3 Plus auto-level sensor Mount for the twin dual extruder sled, and fits on the right hand side as shown - using the captive nut system, and another nut and bolt ( 3M ) This was too tight the first iteration, so I have added tolerance you could also use doudle sided tape, but mine is really tight without that. I am mounting it directly to the sled. Use some BlueTack to hold a nut onto your finger to get the nuts on if you need to - or superglue them to a glove :) This is only if you are setting your printer up similar to mine. The printer needed a lot of modding - and this is my attempt to get it going. Print the item on the front side and it needs no supports - minimal bridging - printed on a 'real' Prusa i3 MK3. I hope this is helpful to you - please show a photo of it installed. Printed in PLA 50% infill - no supports required. Ta !
Statistics
Likes
3
Downloads
0