Ikea Lack Foot For Balance/Stability [2-4mm offsets - w/ or w/o disc]

Description

A 50.5mm x 50.5mm input square for shaky Lack Legs with a disc (10cm diameter) whose surface area probably helps with stability. Mostly, I used this quick thing to boost up a leg that wasn't given enough turns before permanently installing leg braces. Although, bits of cardboard stacked underneath might also work. ... I've also included a few alternatives if you plan on printing four and one of your legs was as troublesome as mine. (Hopefully the extra options don't make things too confusing. I used 2mm by default for my leg). Each measurement refers to the height of the inner-supporting portion of the foot. If balancing your table ends up requiring <1mm divisions, send me a message and I'll upload an extra. Notes: -There are, like, probably too many Lack leg mods out there so snoop around a bit before committing -If you're placing your table near a corner on a carpeted floor. Keep in might the carpet distorts at the edges and will cause some imbalance. -Also, trim around the disc (or message me or print a disc-less version) if you want to install, say, the back leg very close to a corner --Cheers

Statistics

Category

Tags