Ender 3 (2019) Filament Spool Holder with Dual Bearings
Description
This is simply a remix of dominikf's original spool holder to use the original spool nut that was with my Ender 3 (2019) This is a rather large holder, and is sized for filament with a 50-55mm interior diameter. I primarily use Hatchbox, and this holder fits perfectly. Additionally it is shorter than some other holders, with a 78mm clearance. Again the Hatchbox fits quite nicely with a 70mm width This uses two 608 bearings, and just be sure to double up on the bearing holder when you print it. (Honestly if you're not careful it is easy to snap the bearing holder at the base when you're inserting the bearing. You might want to print a third just in case)
Statistics
Likes
15
Downloads
0