Hub Motor Wheel Sleeve (G2T)
Description
Allows you to mount ordinary longboard wheels like you would on a belt drive board to Backfire G2T hub motors.(https://backfireboardsusa.com/products/electric-skateboard-hub-motors-for-backfire-g2t?variant=22079563137142) Only thing required hardware wise is a 12mm threaded rod and threaded rod coupler. Remove the urethane from the hub motor and replace the locknut on the axle with the threaded rod coupler and a short 8mm rod extension. You might have to cut the coupler a little in order for it to fit precisely with the wheel or not be too long. Don't forget to add washers where needed for it to spin without friction.
Statistics
Likes
6
Downloads
0