Autolevel / Dual Alu Extruder carriage for printrbot plus
Description
This Is My New Extruder Carriage For My Printrbot Lc+ V1. It'S Designed To Accomadate All Those Cool New Features, Including The Alu Extruder And The Auto Bed Level Sensor. Should Print And Press Together Just Fine With A .5Mm Nozzle. Smaller Nozzles May Have Looser Part Fittings. Designed To Use Original Hardware, With The Exception Of M3X20 Screws To Hold The Fans On. Mounts Directly Onto The 4-Screw Attachment Point. Note: This Is Quite Imperfect. The Autolevel Holder Only Mounts Such That It'S Blocking You From Seeing The Probe, And Needs To Be Redesigned. The Back Plate Was Made A Bit Too Tall, So The Top Plate Has Bumps To Compensate. Ideally The Back Plate Would Be The Right Size So The Top Plate Could Be Flat! May Come In A Future Revision.
Statistics
Likes
5
Downloads
0