Creality Ender 3 or 5 Auto Level Mount for M12 probe
Description
This is for a m12 probe, I used it on the Ender 5 and you might have to bend the crimped belt fitting thing to the side to get the probe in or just cut a tiny bit off with your cutters.This will mount left of the hot-end,I had to mirror this to fit the ender 5 with out bumping.I will post the off sets latter Config uploaded is for a Ender 5 (Stock Board), ABL, NO SD (i use octoprint) 2.0.5 Marlin. Probe- LJ12A3-4-Z/BX Blue- Ground - (Used Motherboard input power connector) Brown- 12/24 + (Used Motherboard input power connector) Black- Signal pin on z end stop
Statistics
Likes
14
Downloads
0