Flashforge Finder Spool Holder
Description
###Flashforge Finder 3D Printer Spool Holder The Finder is an affordable 3D printer for K-12 classrooms. However, it does not allow easy mounting of common spools. In designing this holder, I tried an existing one on Thingiverse (thing:1763329), which works but does not quite meet my expectations. Thus, I started a new design. I followed roughly the basic shape, extended the end stopper and added a connector that accommodates the 6-mm filament guide. A few other tweaks are used to save filament and strengthen the holder. **The smallest spool inner diameter that can fit is 45 mm**. #### To Print PLA filament works. PETG or ABS is preferred for strength and flexibility. A 20% infill rate is fine. The resolution does not really matter; 0.2mm should be fine. #### Disclaimer The designer is not in any way affiliated with Flashforge and the design is not approved and/or supported by Flashforge. It is released for the sole purpose of educational user support. ####Reference 1. https://www.thingiverse.com/thing:1763329
Statistics
Likes
10
Downloads
0