Fortnite Victory Umbrella
Description
After looking for a Fortnight victory umbrella, and being dissatisfied with what was available, I set out to design my own. The files that I found were all either not a good representation, or not actually printable, this version is both. The umbrella prints in three pieces, two of the Brella_Half parts, and one Brella_Handle. The handle prints standing on end, and the two umbrella handles are printed standing up on what will become the seam where they are joined. This way everything can be printed easily and quickly with no supports. I printed with .2mm layer height, but I imagine .16mm would only be better as far as final product. After printing, use a Q-tip to rub acetone on the two seam surfaces of the umbrella halfs, and them hold them together on a flat surface like a counter top. The same goes for attaching the handle, although a little cleaning up of the hole in the umbrella top might be required as well; alternatively, I just stuck the end of the handle in acetone, waited for it to soften a bit, and pushed it into the umbrella top. The melted end of the handle will squish into the hole, and become bonded when the acetone evaporates in a minute or so.
Statistics
Likes
1
Downloads
0