Articulated Snake Puzzle first design version
Description
This is the first version of the snake i did - have not printed it as it requires far too much support - have been working on an update to this recently (December 2021) where it will need little to no support. This puzzle once put together will be articulated like those wiggly things - and then the entire thing is held together with the eye pin - once the eye is removed all the parts are able to come apart. All the parts in the file are currently all still in position forming the snake - but they would need to be separated and printed using supports. this would not be easy to print as there will be a lot of cleaning out afterwards for all the supports between each puzzle piece. I have made the gap tolerance between each piece a lot larger, on my previous upload it was too tight. that said the snake printed will be 600mm length from head to tail (sounds large but for a snake that needed to be cut up two rulers is really not that bad) . I wouldnt recommend that this is made much smaller because obviously the gap between each piece would also then become smaller.
Statistics
Likes
49
Downloads
0