Parabolic reflector for 100W LED
Description
So I wanted to make some parabolic reflector, that was similar to Stratus LED Reflector, but didn't have the money to buy the product just for some homemade LED flashlights. It should fit most of 20-100 W LEDs The holes for the screws are 34 mm spaced apart (from the center of the holes). I used M3 bolts. You should probably coat the inside faces with some silver/chrome paint, so that the light will bounce off the walls. Look also into 'Another reflector' section down below. Dimensions: Bottom LED cutout: 25mm square Holes spacing: 34mm apart Upper 'ring' size: 114mm diameter
Statistics
Likes
12
Downloads
0