2020 V Slot / Openbuild Direct Drive Carriage Tronxy X5
Description
A Direct drive Carriage for V-Slot extrusions. I Replaced the Carriage on my Tronxy X5SA with this one. No support needed. sacrificial layer in 2 holes. just poke trough. There are 2 Versions. The front is the same. the back is either to mount a 40mm fan for pancake steppers or to fit a normal stepper motor. The wheel tensioning mechanism is not in the best spot, so you have to test how long the M3 screws can be I use these clips https://www.thingiverse.com/thing:3528928 to secure the belt There is a bracket included to mount the Tronxy X-Endstop. There is a bracket included, that allows to equal belt tension. How to: 1. Fix the bracked in place with screws in slotted holes. Dont tighten them yet, the bracket still needs to move along the slots. 2. Fix the bracket in the center with a screw or a stick in one of the top holes 3. Tighten your belts. 4. Remove the screw or stick in top hole. the bracket will move slightly, when the belt tension was not equal. 5. Tighten the screws in the slotted holes. Done You need at least: 2x M5x30 or longer(from stock X5SA carrier) M5 Washers 1x M5x35 or longer 3x M5 Nuts 3x V-Wheels (from stock X5SA carrier) 6x 8mm spacers (from stock X5SA carrier+spare) 2x M3x12 or M3x14 or probably M3x16 optinal 2x m3 nuts
Statistics
Likes
13
Downloads
0