SKR v1.3 external case 120mm fan cooling
Description
Hi all, I designed this SKR v1.3 case for a 120mm fan to maximize cooling. I run my Anycubic Kossel Linear Plus with TMC2208s and SKR v1.3 fast. This means a lot of heat generated and with the old Anycubic style of putting the electronics underneath the heated bed, my roommate and I (who I share the printer with) were concerned about overheating and lifespan of these parts. While we had a 4010 fan blowing on it when it was underneath the bed, we were concerned about cooling and, if we put a larger fan, about messing with the bed temp. While I could have designed a complex fan system that would cycle the air out of the printer without even touching the bed, we decided to go with the external case for a few reasons: we do not move the printer a lot, we make a lot of modifications and enjoy easy access, and we wanted to put the biggest possible fan on there as possible to maximize the cooling. Apologizes about the awful wire management in the picture-- still working on a solution to that! If this could solve a problem you have, like we had, then I'm glad and thank you for downloading!
Statistics
Likes
1
Downloads
0