Arrma 6s Shock Bushing for 3s Vehicles
Description
This is an Arrma 6s upper shock bushing which allows installation of 6s shocks onto 3s Arrma vehicles. This would be a functional alternative to Axial bushing commonly used for this, Axial Part #AXA1356. Printed in Ninjaflex TPU, 100% infill 0.4mm nozzle. The ninjaflex is one of the most flexible if not the most flexible of TPU filaments out there and that allowed me to squeeze this through the eye of the shock cap with just a hobby screwdriver. If you print in a harder TPU it may be a challenge to fit through the eye hole. If you can't fit it through then cut off one of the ends to feed it through and use some washers to fill up the gap left on the other end. Get the Axial bushing here: https://www.amazon.com/Axial-AXA1356-Silicone-Shock-Bushing/dp/B0051W7R1M
Statistics
Likes
19
Downloads
0