FaceShield RC1 A4 punched pocket version
Description
This is a derivative of the [Prusa face shield](https://blog.prusaprinters.org/from-design-to-mass-3d-printing-of-medical-shields-in-three-days/), and is a variant of their Release Candidate 1 ('RC1'), adapted to use an A4 [punched pocket](https://en.wikipedia.org/wiki/Punched_pocket), which you might find at your local supermarket, and it is very possible that you have hundreds lying around in the office already. You can also use a perforator on the 'A6' setting to punch holes from both sides. You're able to easily attach/detach a perforated pocket, allowing you to replace these away after a single use. The 3D printed part can be soaked with soapy water to clean it. It is reusable. You can attach a 'buttoned elastic band' [as mentioned in the original Prusa blog article](https://blog.prusaprinters.org/from-design-to-mass-3d-printing-of-medical-shields-in-three-days/). A thick rubber band with holes in it also works well. If you have other ropes or threads, you can use these as well; I have included to small holes that you could thread these through if desired. Also find it on the PrusaPrinters community: https://www.prusaprinters.org/prints/26761-faceshield-rc1-a4-punched-pocket-version --- A 'slim & fast' version has been uploaded now as well. This removes the hexagonal headband structure, and reduces height to roughly 60% of the original model, meaning that it can print significantly faster.
Statistics
Likes
3
Downloads
0