Reusable Nappy Odour Removal Drying Hood
Description
After using a portable clothes hanger to dry out the soiled reusable nappies, I finally had enough of the smell in the bathroom. So after a bit of searching I found that a system using an OdourCube carbon module would do the trick. So I designed a hood which would connect using the same clips that came with the system. I attached the pegs to the bottom and it was ready to go. It's not the neatest solution in the world but it does the job! I printed the hood in two halves using ABS on a Prusa Mk3s and then glued together and attached pegs using zip ties. The rest of the system uses the following OdourCube components: 1 x 75mm Fan - https://odourcube.com/collections/modules/products/75mm-fan-module 1 x 75mm Carbon Module - https://odourcube.com/collections/modules/products/75mm-carbon-module 1 x Panel Mount Set - https://odourcube.com/collections/modules/products/panel-mounts 2 x Clip Set - https://odourcube.com/collections/modules/products/clips I had a spare power supply which I used, but you could use this one as well: https://odourcube.com/collections/modules/products/12v-power-supply I hope this might help someone!
Statistics
Likes
1
Downloads
0