MDRK offroad wheels for Traxxas 1.9 tires
Description
Made some replacement wheels for Traxxas TRX4. The wheels started spinning inside the tires and as I was not keen on gluing them, I decided to create some "beadlock" type rims instead. The rim consist of 3 parts - the face or the outer part, the locking or inner part and a compression ring. Extras required are 5-6 M2.5x10-12 screws. The compression ring goes inside the tire followed by the other 2 pieces each from either side. Printed at 0.2 layer height and supports touching bed. 15% grid infill. The mating surfaces are on the bed. Recommend some pre-drilling to get accurate holes - 2 mm for the outer part and 2.5 mm to the inner part.
Statistics
Likes
35
Downloads
0