Delta Kossel printer calibration test
Description
This is a printer test , made from scratch but started from a guide of Alessio Ausilio, every credit to him. The Alessio source is this: https://www.thingiverse.com/thing:2972770 I putted my part as remixed from him but recent change of thingverse site seem to not show it. I made this a bit bigger and with a clear indication on part of which tower you are reading. The towers on cad (and on slicer if everything is fine) are setup in this way: X on the left Y on the right Z at the rear position Size is 80mm ON EXTERNAL PART, there is also circle to see correct round print and also useful to remove printed part. For calibration you can misure and recalcolate, there is many guide on internet or you can check the blog of Odino for a very simple and useful guide. NOTE my part is 80mm , the Alessio guide is based on a 60mm part (i think in my case bigger was better.. ). You not need to print all the high part... often after 5 mm is already good to check. No support or raft need, thinked to print 0.3 layer high, 2 perimeters 0.4, 2 bottom layer. Thanks again to Alessio Odino. NOTE on 30/03/2020 coorected link to Alessio's thing
Statistics
Likes
2
Downloads
0