Ender 3 X-Axis belt idler - Using extruder upgrade parts
Description
This is a remix from; https://www.thingiverse.com/thing:3213418 I changed the design so I was able to only use left over parts from when i upgraded my stock extruder to an aluminium one. The screws i used to reattach the motor to the x arm were the old screws that came installed on my extruder motor, i had to cut a bit of plastic and push the screws through so i could offset the motor a bit and tighten the screws holding the motor all the way. All the screws and bolts were things i had laying around after i upgraded the extruder, and some of them were left overs from when i assembled my Ender 3.
Statistics
Likes
6
Downloads
0