Spyro the Dragon (poses: Okay) monochrom
Description
As I was asked on how to print this one in one color I made a short remix for single material printing. In the set: Body (scale to 400% OR 230%) Wings separated for less supported printing 2 sets of Wings (please see Print instructions for further information) Print Instructions First you have to decide if you want a very big Dragon which need almost your full Z height or a hand tame small Dragon. For the big Dragon: Load the body and scale it to 400% Load the Wings and also scale them to 400% arrange it on your print bed and enable support. For the small hand tame Dragon: Load the same body and scale it to 230% Load the Wings with "thicker" in the filename and scale it to 230% Why using the thicker wings? Because otherwise you will have issues with thin walls and gaps in the model.
Statistics
Likes
18
Downloads
0