E3D Hemera Ender 3 Mount (no extra screws)
Description
A E3D hermes/hemera mount for ender 3, without needing extra screws (for those like me don't have other screws lying around). Instructions: 1. Disassemble x carriage. 2. Press fit hex nut into printed part, ideally use a soldering iron. (allow top roller screws from the back just like the bottom roller) 3. Attach hemera with 2x M3x8mm and square nuts on the (from hemera fixings) through printed part to t-slots on the side. 4. Insert M3x16mm (from original ender 3 hotend) from the back through x carriage metal plate and printed part to motor t-slot. 5. Re-assemble rollers and belt. PLA is fine for heat resistance, if doubt use PETG, ABS, PC...etc. Offsets nozzle x: -15, y: -10, z: -0.7(adjust bed a bit)
Statistics
Likes
2
Downloads
0