2020 filament guide (thicker version)
Description
I needed a few of these for my Creality Ender 3 Pro with 3DChameleon Dual Extruders to guide my filament from the spool on one side. However, I had two problems: the base of the clip is too thin for my M4x10 screws with a t-nut (the screw would bottom out on the 2020) and the orientation of the loop needed to be rotated 90 degrees for the 4040's on either side of the z-axis. So, I used Fusion 360 to extrude the base by 3mm so it not only would accomodate my M4x10's, but also add strength to the clip (the original snapped in half as soon as I put any torque on the M4 screw when attached). Then I used the rotated loop clips on the sides to guide the filament into either extruder.
Statistics
Likes
2
Downloads
0