NCASE M1 and Lian Li PC-Q33 side panel clips (may fit other lian li cases)
Description
These are the clips that hold the side panels in on the NCASE M1 and Lian Li PC-Q33 (and maybe other) cases. I've tried in ABS and it works well, so far it's went through a lot of cycles of me taking the panels on and off. Not sure if PLA would be up to the job but it's a small print so ABS should be possible without an enclosure for this. You probably need at least a 0.4mm nozzle but smaller might help for this. https://ncases.com/products/m1_panel_clips
Statistics
Likes
12
Downloads
0