Faster Printing Version of Creality's N95 Buckle Design
Description
This is a re-design of the Creality open-source N95 mask buckle. This design removes 50% of total mass, reducing resource usage and print time by up to 50% or more, potentially doubling your print output per hour. This design has been tested and works great as thin as 0.5mm and as thick as 1.5mm. The provided model is 1mm thick, and you can adjust this using Blender, CAD, etc. I use the following settings on my CR-10S5 with a 0.4mm nozzle: 0.28mm layers 2 walls 1 top/bottom layer 20% gyroid infill 40mm/s print speed And these settings with a 0.8mm nozzle and an E3D Volcano: 0.6mm layers 1 wall 1 top/bottom layer 20% gyroid infill 30mm/s print speed I can print 6 in an hour and a half with the 0.4mm nozzle settings Nylon, ABS, or PETG would probably work best for these, but PLA works fine. Hospitals and clinics will likely want them made of Nylon, ABS, or PETG exclusively due to PLA's difficulties with harboring bacteria and being difficult to sanitize. If you're going to use these for yourself, friends, and family, give each person one to use for themselves ONLY - not to share among people. These are also meant to be disposable.
Statistics
Likes
4
Downloads
0