FPV monitor/ receiver housing
Description
I wanted an FPV monitor so any onlookers could go for a ride. I made two different variants, why? because I had the time/resources. I am afraid to say you are on your own for the print settings, (high enough infill to make it stable). I added a step down converter so I can use up to 6s (not tested) i have tested 2,3,4s (you have to initially tune the converter with a Philips(set it and forget it). (links below) I printed one from PLA and the other from ABS: yes ABS is a pain until you get it locked in. Designed in F360 If you request I will put the F3D files up (or brep to mesh/mesh to brep in fusion, face count should be low enough) (I cannot locate the cover for the TrueD module at this time 4/01/2020
Statistics
Likes
0
Downloads
0