MagicMirror RIBBA covers
Description
I have a MagicMirror which is built into a 7x50cm Ikea Ribba frame. I wanted to upgrade the MM with a Grove gesture sensor to control it (PAJ7620U2). But as the frame does not provide any good options, I designed some covers which can hold it and have a small cut out for the sensor. Additionally I designed also a holder for a RCWL-0516 microwave sensor on the back of the bottom cover and added a SD card reader extension to easier access the RPi' SD card. I had to cut the cover into three pieces as the total length is 53cm and they wouldn't fit in one piece on the Ender 3 bed. The areas where the pieces come together are covered by additional T-shaped covers, which are superglued on the cover. To make the design more pleasant I designed also a cover for the top of the mirror. The plan is to add later a LED strip, too. ;-)
Statistics
Likes
1
Downloads
0