Taptes Model 3 (or Y) USB Hub Cover for Raspberry Pi 4
Description
Created an expanded cover for the Taptes Tesla Model 3 Usb Hub to fit a Raspberry Pi 4 inside. This is the hub: https://www.taptes.com/products/taptes-model-3-usb-hub-designed-for-tesla-model-3-dashcam-sentry-mode-model-3-hub A couple of the photos I added black flocking on it to match the interior look of the car and another couple of photos are just of the bare 3D printed part. IMPORTANT - 1. You will need to purchase 4x 5mm by 2mm round magnets (you probably can't buy just 4x because they are so cheap) 2. Your enclosure case on the Raspberry Pi 4 should not be more than 25mm thick. If you have a thicker case than this, contact me, I'll do a remix. But the case should be a just-fit within the hub because you don't want the Pi to rock around during driving. The case I'm using is this: https://www.amazon.com/dp/B07VD568FB/ref=cm_sw_r_tw_dp_U_x_UlMIEbYCS1C13
Statistics
Likes
16
Downloads
0