GEPRC CineQueen 3inch Prop and Motor Guard V2 - no propwash
Description
V2 has a rough circle. I found this harder than a complete circle. This thing has also been applied to V1 in the link below: https://www.thingiverse.com/thing:4229437 In addition, by cutting off some of the aspects of looking at FC, the weight was reduced by 2 grams per piece(total 8 grams less), which resulted in the complete removal of the propwash and more stable flight. And the insertion and release of SD card have become easier, and the insertion of USB connector has become much simpler. Check out the YouTube video below. There is no stabilization at all. https://youtu.be/USIMXrRPY7U This fits well with other 3inch quad, but motor hole size is 9mm. Caution : When tightening the bolts, do not tighten too hard and tighten the four bolts alternately to the same depth. V1 users can refer to pictures and cut 5mm from the top of a portion of the side close to the FC(one-third of the total circle).
Statistics
Likes
7
Downloads
0